Supermicro SuperServer SYS-121H-TNR - Removing the Processor from the Processor Carrier Assembly

44
Chapter 3: Maintenance and Component Installation
Removing the Processor from the Processor Carrier Assembly
Once you have removed the processor carrier assembly from the PHM, you are ready to
remove the processor from the processor carrier by following the steps below.
1. Unlock the lever from its locked position and push the lever upwards to disengage the
processor from the processor carrier as shown in the drawing on the right below.
Lever
CPU Carrier Assembly (carrier E1A)
SP XCC HBM
CPU Carrier Assembly (carrier E1B)
SP MCC
Lever
2. Once the processor is loosened from the carrier, carefully remove the processor from
the processor carrier.
Note: Please handle the processor with care to avoid damaging the processor and
its pins.