Supermicro SuperServer SYS-121H-TNR - Removing the Bezel; Installing the Bezel

31
Chapter 3: Maintenance and Component Installation
Removing the Bezel
1. Unlock the bezel with a key.
2. Press the red release lever and remove the bezel from the chassis.
Installing the Bezel
1. Align the bezel with the pins at the left of the chassis.
2. Hold the release lever while pushing the bezel onto the chassis front.
3. Release the hold on the lever.
4. Lock the bezel with a key.
Figure 3-2. Front Bezel