Supermicro SuperServer SYS-121H-TNR - Removing the Processor Carrier Assembly from the PHM

43
Chapter 3: Maintenance and Component Installation
Removing the Processor Carrier Assembly from the PHM
To remove the processor carrier assembly from the PHM, please follow the steps below:
1. Detach the four plastic clips (marked a, b, c, d) on the processor carrier assembly from
the four corners of the heatsink (marked A, B, C, D) as shown in the drawings below.
Pin 1
a
c
b
d
A
C
D
B
1U Heatsink (View of Component Side and Heatsink Bottom Side)
Pin 1
a
c
b
d
A
C
D
B
SP XCC
HBM
Pin 1
a
c
b
d
A
C
D
B
SP MCC
2. When all plastic clips are detached from the heatsink, remove the processor carrier
assembly from the heatsink.
SP XCC HBM SP MCC
1U Heatsink (View of Component Side and Heatsink Bottom Side)