Supermicro SuperServer SYS-121H-TNR - Page 96

96
Chapter 6: Optional Components
4. Choose whether to make the NVMe drives in this IOU HotPlugCapable by selecting
Enabled or Disabled.
5. Repeat steps 4 through 7 for each IOU # on each CPU to enable VMD on the desired
NVMe ports.
Figure6-12.BIOS,EnablingSocket1Completed(Example)
(This example shows SYS-621H-TN12R with 12 NVMe. Other systems will look di󰀨erent.)
6. Press [F4] to save the conguration and reboot the system.
Note: If there is an existing RAID conguration, delete the RAID volume associated with
the VMD controller before disabling the controller. Failure to do so may lead to unexpected
behavior.
Note: The e󰀨ects of physically changing or swapping a CPU on the VMD controller have
not been thoroughly tested or documented.