Supermicro X10DAL-i - Internal Speaker, Power LED;Speaker

Chapter 2: Installation
2-27
BT1
JPCIE3
LEDPWR
I-SGPIO2
LE6
JBT1
BIOS LICENSE
JPI2C1
JTBT1
J24
JPWR1
JPWR2
JF1
JD1
JHD_AC1
JSPDIF_OUT
JSPDIF_IN
J21
JL1
JSD1
JSD2
JSTBY1
JTPM1
JVRM2
JVRM1
JPAC1
JPL2
JPL1
JPUSB1
JBR1
JI2C2
JPME2
JI2C1
J23
SP1
FAN3
FANA
FAN6
FAN4
FAN2
FAN1
MAC CODE
X10DAL-i
BAR CODE
AUDIO FP
HD AUDIO
(3.0)
USB5/6
(3.0)
USB7/8(3.0)
USB1/2
USB0
USB3/4
S-SATA2
S-SATA0
S-SATA1
S-SATA3
I-SATA5
CPU1 SLOT1 PCI-E 3.0 X8 (IN X16)
I-SATA4
CPU2 SLOT2 PCI-E 3.0 X4 (IN X8)
I-SATA3
I-SATA2
I-SATA1
CPU1 SLOT3 PCI-E 3.0 X16
I-SATA0
CPU1 SLOT5 PCI-E 3.0 X16
P2-DIMME1
P1-DIMMC1
P2-DIMMF1
P1-DIMMD1
P2-DIMMH1
P1-DIMMB1
P1-DIMMA1
LAN2
P2-DIMMG1
LAN1
COM1
I-SGPIO1
S-SGPIO
PCH SLOT6 PCI-E 2.0 X4 (IN X8)
JWD1
Rev. 1.02
1
FAN5
CPU1
CPU2
Battery
PCH
BIOS
A. Internal Speaker
(Buzzer)
B. PWR LED/Speaker
Power LED/Speaker
On the JD1 header, pins 1-3 are used
for power LED indication, and pins
4-7 are for the speaker. Please note
that the speaker connector pins (4-7)
are used with an external speaker. If
you wish to use the onboard (internal)
buzzer, please close pins 6-7 with a
jumper. See the tables on the right for
pin denitions.
Speaker Connector
Pin Settings
Pin # Denition
4-7 External Speaker
6-7 Internal Speaker
Internal Speaker
The Internal Speaker, located at SP1,
can be used to provide audible indica-
tions for various beep codes. See the
table on the right for pin denitions.
Refer to the layout below for the loca-
tion of the Internal Buzzer (SP1).
Internal Buzzer (SP1)
Pin Denition
Pin # Denitions
1 Pos. (+) VCC
2 Neg. (-) Beep In
PWR LED
Pin Denitions
Pin # Denition
1 Anode (+)
2 Cathode (-)
3 NA
A
B