Supermicro X10DAL-i - X10 DAL-i Jumpers

Chapter 1: Overview
1-5
JPME1 ME Recovery Pins 2-3 (Normal)
X10DAL-i Jumpers
Jumper Description Default Setting
JBT1 Clear CMOS See Chapter 2
JI
I2
C1/JI
I2
C2 SMBus to PCI-E slots Pins 2-3 (Disabled)
JPAC1 Audio enable Pins 1-2 (Enabled)
JPL1 GLAN1 Enable/Disable Pins 1-2 (Enabled)
JPL2 GLAN2 Enable/Disable Pins 1-2 (Enabled)
JPME2 ME (Manufacture) Mode Select Pins 1-2 (Normal)
JPUSB1 USB 0/1 Wake-up Enable Pins 1-2 (Enabled)
JWD1 Watch Dog Pins 1-2 (Reset)
J21 LAN controller EEPROM update Open (Disabled)
X10DAL-i Connectors
Connectors Description
Audio_FP Audio connector for front access
HD Audio 5.1 HD (6-channel High-Denition) + SPDIF audio connector
BT1 Onboard CMOS battery (See Chapter 3 for used battery disposal)
COM1 Serial port header
CPU1 Slot1 PCI-E 3.0 x 8 in 16 slot
CPU2 Slot2 PCI-E 3.0 x 4 in 8 slot (This slot is available when CPU2 is installed.)
CPU1 Slot3/Slot5 PCI-E 3.0 x16 slots
PCH Slot6 PCI-E 2.0 x4 in x8 slot (See the note below for Thunderbolt AOC sup-
port.)
FAN1-6, FANA CPU/System fan headers
J24 ATX 24-pin power connector
JD1 Speaker/Power LED indicator
JF1 Front panel control header
JL1 Chassis intrusion header
JPI2C1 Power supply SMBbus I
2
C header
JPWR1/JPWR2 12V 8-Pin power connectors
JSD1/JSD2 SATA DOM (Device_On_Module) power connection headers 1/2
JSPDIF_In SPDIF_(Sony/Philips Digital Interface)_In header
JSPDIF_Out SPDIF_(Sony/Philips Digital Interface)_Out header
Note: This motherboard supports the latest Thunderbolt technology. For
proper Thunderbolt support, please install the Thunderbolt add-on card on
PCH Slot6 and connect the GPIO cable from the Thunderbolt add-on card
to the GPIO header (JTBT1) on the motherboard for TBT hot-plug support.
JBR1 BIOS Recovery Pins 2-3 (Normal)