C-2
X10DAL-i Motherboard User’s Manual
Note: If the system fails to locate the BIOS binary image, four short beeps
will sound and trigger a system reboot. Please load the "Super.ROM" le
to the root folder and connect this folder to the system. (You can do so by
inserting a USB device that contains the new "Super.ROM" image to your
machine for BIOS recovery.)
4. After locating the new BIOS binary image, the system will enter the BIOS
Recovery menu as shown below.
Note: At this point, you may decide if you want to start with BIOS recovery.
If you decide to proceed with BIOS recovery, follow the procedures below.
To perform UEFI BIOS recovery using a USB-attached device, follow the instruc-
tions below.
1. Using a different machine, copy the "Super.ROM" binary image le into the
disc Root "\" Directory of a USB device or a writeable CD/DVD.
Note: If you cannot locate the "Super.ROM" le in your driver disk, visit
our website at www.supermicro.com to download the BIOS image into
a USB ash device and rename it "Super.ROM" for BIOS recovery use.
2. Insert the USB device that contains the new BIOS image ("Super.ROM") into
your USB drive and power on the system
3. While powering on the system, please keep pressing <Ctrl> and <Home>
simultaneously on your keyboard until you hear two short beeps. This may
take from a few seconds to one minute.
To Next Page
Loading...
