Supermicro X13SCL-IF - Page 101

Chapter 4: UEFI BIOS
101
*If the Conguration Address Source is set to Static, the following features will
become available for conguration:
Station IP Address
This feature displays the Station IP address for this computer. This should be in decimal and
in dotted quad form (i.e., 192.168.10.253).
Subnet Mask
This feature displays the sub-network that this computer belongs to. The value of each three-
digit number separated by dots should not exceed 255.
Station MAC Address
This feature displays the Station MAC address for this computer. Mac addresses are six
two-digit hexadecimal numbers.
Gateway IP Address
This feature displays the Gateway IP address for this computer. This should be in decimal
and in dotted quad form (i.e., 172.31.0.1).
VLAN
This feature enables the BMC VLAN function. The options are Disabled and Enabled.
*If the feature above is set to Enabled, the following feature will become available
for conguration:
VLAN ID
Use this feature to enter the VLAN ID. The default setting is 1.
*****************************
Congure IPv6 Support
*****************************
IPv6 address status
This section displays status of station IPv6 address to BMC.
IPv6 Support
Use this feature to enable IPv6 support. The options are Enabled and Disabled.