Supermicro X13SCL-IF - Page 100

Super X13SCL-IF User's Manual
100
When SEL is Full (Available when "SEL Components" is set to Enabled)
This feature allows you to decide what the BIOS should do when the system event log is full.
Select Erase Immediately to erase all events in the log when the system event log is full. The
options are Do Nothing and Erase Immediately.
Note: All values changed here do not take e󰀨ect until computer is restarted.
BMC Network Conguration
--BMC Network Conguration--
Update BMC LAN Conguration
Select Yes for the BIOS to implement all IP/MAC address changes at the next system boot.
The options are No and Yes.
*If this feature above is set to Yes, the following features will become available for
conguration:
*****************************
Congure IPv4 Support
*****************************
BMC LAN Selection
This feature displays the BMC LAN setting. The default setting is Failover.
BMC Network Link Status
This feature displays the BMC Network Link status. The default setting is Dedicated LAN.
Conguration Address Source
This feature allows you to select the source of the IP address for this computer. If Static
is selected, you will need to know the IP address of this computer and enter it to the
system manually in the eld. If DHCP is selected, the BIOS will search for a Dynamic Host
Conguration Protocol (DHCP) server in the network that is attached to and request the next
available IP address for this computer. The options are DHCP and Static.
*If the Conguration Address Source is set to DHCP, the following features will
become available for conguration:
• Station IP Address
• Subnet Mask
• Station MAC Address
• Gateway IP Address