4-18
X9DRH-7F/-iF/-iF-NV/-7TF/-iTF Motherboard User’s Manual
VGA Priority
Use this feature to specify which graphics controller to be used as the primary boot
device. The options are Onboard and Offboard (VGA).
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unied
Extensible Firmware Interface) for network stack support. The options are Enabled
and Disabled.
SuperIOConguration
Super IO Chip: This item displays the Super IO chip used in the motherboard.
SerialPort1Conguration
Serial Port
Select Enabled to enable serial port 1. The options are Enabled and Disabled.
Device Settings
This item displays the settings of Serial Port 1.
Change Settings
This option species the base I/O port address and the Interrupt Request address of
Serial Port 1. Select Disabled to prevent the serial port from accessing any system
resources. When this option is set to Disabled, the serial port becomes unavailable.
The options are Auto, IO=3F8h; IRQ=4; IO=3F8h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;
IO=2F8h; IRQ=3, 4, 5, 6, 7, 10, 11, 12; IO=3E8h; IRQ=3, 4, 5, 6, 7, 10, 11, 12; and
IO=2E8h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;
Device Mode
Use this feature to select the desired mode for a serial port specied. The options
are Normal and High Speed.
SerialPort2Conguration
Serial Port
Select Enabled to enable serial port 2. The options are Enabled and Disabled.
Serial Port Mode
This feature allows the user to set the serial port mode for Console Redirection.
The options are SOL and COM.
To Next Page
Loading...
Need help?
General
