Supero X9DRL-iF User Manual

4-16
X9DRL-3F/X9DRL-iF User’s Manual
PCH Slot1 PCIE 2.0 x1 OPROM, PCH Slot2 PCI OPROM, PCI Slot3 PCIE
2.0 x4 OPROM, CPU1 Slot4 PCIE 3.0 x8 OPROM, CPU1 Slot5 PCIE 3.0 x8
OPROM, CPU1 Slot6, PCIE 3.0 x8 OPROM
Select Enabled to enable Option ROM support to boot the computer using a
network interface from the slots specied above. The options are Enabled and
Disabled.
Onboard LAN Option ROM Select
This feature selects whether to load the iSCSI or PXE onboard LAN option ROM.
The options are iSCSI and PXE.
Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM
Select Enabled to enable the onboard LAN1 Option ROM~LAN4 Option ROM.
This is to boot the computer using a network device. The default setting for LAN1
Option ROM is Enabled. The default setting for LAN2 Option ROM is Disabled.
VGA Priority
Use this feature to specify which graphics controller to be used as the primary boot
device. The options are Onboard and Offboard (VGA).
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unied
Extensible Firmware Interface) for network stack support. The options are Enabled
and Disabled.

SuperIOConguration(WPCM450)
Super IO Chip
Displays the Super IO chip type.

SerialPort1Conguration/SerialPort2Conguration
The submenus allow the user to congure the following settings for Serial Port
1 or Serial Port 2:
Serial Port
Select Enabled to enable a serial port specied by the user. The options are
Enabled and Disabled.
Serial Port Mode
This feature allows the user to set the serial port mode for Console Redirection.
The options are SOL and COM.

Supero X9DRL-iF Specifications

General

Brand	Supero
Model	X9DRL-iF
Category	Motherboard
Language	English