suprema bioentry PLUS - Network Default Setting; Initializing Network Settings

26
ⒸCopyright 2007 Suprema Inc.
Network Default Setting

In case of forgetting network setting of BioEntry Plus (TCP/IP or RS-485 setting) during
installation or using BioEntry Plus, user can initialize network setting (TCP/IP or RS-485
setting) by using DIP SW installed on the back panel of BioEntry Plus. Please refer to the
figures in below.
How to initialize Network Setting

1. Turn off BioEntry Plus power.

2. Please make DIP SW #2 “ON” (Please refer to Fig.1)

3. After turning on BioEntry Plus power, user can modify
TCP/IP or RS-485 setting what user wants.

4. Please modify TCP/IP or RS-485 setting and save it.

4. Please make DIP SW #2 “OFF” (Please refer to Fig.2)

5. After recycling BioEntry Plus power, please check the
modified TCP/IP or RS-485 setting.
1
2
O
N
1
2
O
N
<Fig.1>
<Fig.2>
1
2
O
N
1
2
O
N
 Network Default Setting
- TCP/IP Address : 192.168.0.1
- Not checked “Use Server”
- RS-485 : PC Connection, 115200bps