SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | support@surecall.com
11
Specications
Email: support@surecall.com
Or, chat: www.surecall.com, 7:00 AM – 5:00 PM PST, Monday – Friday
Problem Resolution
Signal booster has no power Connect the power supply to an alternate power source.
Be sure the power source is not controlled by a switch that can remove power from the outlet.
Check the POWER LED () on the signal booster. If it is OFF, return the power supply to SureCall. Contact
tech support at to receive an RMA at:
1-888-365-6283 or support@surecall.com, or go to www.surecall.com 7:00 AM – 5:00 PM PST, Monday –
Friday to chat with a representative.
After installing your signal
booster system, you have no
signal or reception
Verify that cable connections are tightly tted to the booster and antenna.
Try further separating the booster and antenna.
Verify that there is usable signal where the antenna is placed.
Remember: Bars are not always a reliable measure of signal. The best way to conrm signal coverage is
the ability to place and hold a call.
FLARE SPECIFICATIONS
U.S. Canada
5-Band Kit with Omni
(SC-Poly-DT-O-Kit)
5-Band Kit with Yagi
(SC-Poly-DT-CA)
Dual Band Kit with Yagi
(SC-Dual-DT-Y-CA)
Uplink Frequency Range (MHz): 698-716 / 776 – 787 / 824-849 / 1850-1915 / 1710-1755 824-849 / 1850-1915
Downlink Frequency Range (MHz):
728-746 / 746 – 757 / 869-894 / 1930-1995 / 2110-2155 869-894 / 1930-1995
Donor/Server Port Impedance: 75 ohm / 50 ohm
Maximum Gain: 72 dB 75.1 dB 78.9 dB
Noise Figure: 7 dB
VSWR: ≤2.0
Supported Standards: CDMA, WCDMA, GSM, EDGE, HSPA+, EVDO 4G and all cellular
standards
CDMA, WCDMA, GSM, EDGE,
HSPA+, EVDO
AC Input: Input: AC 110 – 240 V, 60 Hz ; Output: DC 5V / 3A
Maximum Output Power: 1 Watt EIRP 3 Watt EIRP
Cable: RG6 (50 ft.)
RF Connectors: Donor port: F Female, Server port: Integral
Power Consumption: <12W
Weight: 1. 8125 lb.
Dimensions: 5.125 × 7.25 × 5.625 inches
FCC ID / IC: RSNDT 7784A-FLARE 7784A-FLAREDB
Max Coverage Area: 2,500 Sq. Ft. 3,000 Sq. Ft.