SureCall Flare - Step 3. Place the Booster; Step 4: Connect to Power; Step 5: Enjoy Boosted Signal

SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | support@surecall.com
9
Installation
Step 3. Place the Booster
Place the booster in a central location where signal is needed and at least 25 ft. from the outdoor antenna location.
When placing the booster, note that further separation between the booster and outside antenna will increase
booster performance. Connect the open end of the RG6 cable from the outside antenna to the booster and tighten
connection.
Please note that the performance and range of your
booster depends on three factors:
1. Signal strength at the location of the outside antenna.
2. Interior building materials between the booster and
your mobile device.
3. Distance between the outside antenna and booster
(while at least 25 ft. separation is recommended,
further separation will increase performance).
Note: Fixed stations operating in the 1710-1755 MHz bands are limited
to a maximum antenna height of 10 meters above ground.
This booster should not be used near open re or ame. Storage
and transportation: Store and place in non-extreme room-
temperature and dry environment.
Step 4: Connect to Power
Once the booster and outside antenna are connected
and in place, connect the power cord to the signal
booster and plug into a power outlet.
Note: This booster is rated for 5-15V input voltage. DO NOT use the
booster with a higher voltage power supply. This can damage
the booster, cause personal injury, and void your warranty.
Step 5: Enjoy Boosted Signal
Place a call in the room where the booster is located to
conrm that your phone is receiving a boosted signal.
Remember: Bars are not always a reliable measure of
signal. The best way to conrm signal coverage is the
ability to place and hold a call.
Placing Booster and connecting cable
Connecting the Power Supply