Specifications are subject to change without notice.
© 2004 by SURECOM Technology Corporation. All rights reserved.
Page14
2D
3. COM port configuration
In this chapter, you will be provided with detailed information on how to set up the 24-Port
100/10M N-Way Rack-Mount Smart Switch through a PC terminal emulation program. A terminal
program is required to communicate with the switch’s internal software. Only after the terminal
program setup is done, you are thus able to proceed to set up the 24-Port 100/10M N-Way
Rack-Mount Smart Switch .
Before you are able to access the 24-Port 100/10M N-Way Rack-Mount Smart Switch 24-Port
100/10M N-Way Rack-Mount Smart Switch , you have to configure your terminal emulation
program. Windows O/S provides a suitable program called “Hyper Terminal” for configuration, or
you can choose other third-party products such as “Telix and ProCom” instead.
Connect a RJ-45 Cable to a COM port on your PC and to the console port of your Smart Switch
as the below figure.
To Next Page
Loading...
Need help?
General
