SurePrint SP91 - Page 39

SP91 User Manual
ESC
ESC
ESC
ESC 2
2
2
2
[Name] Select default line spacing
[Format] ASCII ESC 2
Hex 1B 32
Decimal 27 50
[Description] Set the line spacing to 3.75mm (30 ´ 0.125mm).
[Note] Line spacing set independently in stable mode and page mode.
[Reference] ESC
ESC
ESC
ESC 3
3
3
3
ESC
ESC
ESC
ESC 3
3
3
3 n
n
n
n
[Name] Set line spacing
[Format] ASCII ESC 3 n
Hex 1B 33 n
Decimal 27 51 n
[Range] 0 ≤ n ≤ 255
[Description] Set line spacing [n × 0.125mm].
[Notes] · Sets line spacing independently in stable mode
· In stable mode, uses vertical unit (y).
[Default] n = 30
[Reference] ESC
ESC
ESC
ESC 2
2
2
2
ESC
ESC
ESC
ESC ?
?
?
? n
n
n
n
[Name] Cancel user-defin e d characters
[Format] ASCII ESC ? n
Hex 1B 3F n
Decimal 27 63 n
[Range] 32 ≤ n ≤ 126
[Description] Cancel user-defined characters.
[Notes] · This command stops the type which defined for character code, character code set
by n
. After canceling the user-defi ned character, prints with inner character relative mode.
· Select character type by ESC !, this command defect the type which defined the
pointed code.
· If one of the user-defined characters do not define, then the printer ignore this
command.
[Reference] ESC
ESC
ESC
ESC &
&
&
& , ESC
ESC
ESC
ESC %
%
%
%
ESC
ESC
ESC
ESC @
@
@
@
[Name] Initialize printer
[Format] ASCII ESC @
Hex 1B 40
Decimal 27 64
[Description] Clears the data in the print buffer and resets the printer modes to the modes that were in
effect when the power was turned on.
[Notes] · The set of DIP swith and Memory Switch won ’ t check.
· The data in receiving buffer area won ’ t be cleared.