SP91 User Manual
· As sort ascending to transmit [n] k and put one NUL 0 at last
.
When [n] k is less than or equal to the fore data, sets position which be finished, and the
continued data dealt as normal data.
·
ESC
ESC
ESC
ESC D
D
D
D NUL
NUL
NUL
NUL cancel all horizontal position.
· Even if changes the character width, the fore specified horizontal position also do not
change.
· For stable and page mode, character width will be memoried.
[Default] Default position is 8 character spacing (raw 9 ， 17 ， 25 ...) of type A (12 ´ 24).
[Reference] HT
HT
HT
HT
ESC
ESC
ESC
ESC i
i
i
i
[Name] Full cut
[Format] ASCII ESC i
Hex 1B 69
Decimal 27 105
[Description] After receiving this command, the printer executes full cut.
[Note] As it won ’ t feed paper when executing this command, please assures that feed
paper5mm or more before executing this command next time, to avoid that the cutter be
damaged.
[Default] The default is partial cut mode.
ESC
ESC
ESC
ESC J
J
J
J n
n
n
n
[Name] Print and feed paper
[Format] ASCII ESC J n
Hex 1B 4A n
Decimal 27 74 n
[Range] 0 ≤ n ≤ 255
[Description] Prints and outputs the data in print buffer area, and feed paper [n × 0.125 mm ].
[Notes] · After printing, this command set the original position to the beginning of one line.
· The feed paper qua n ti t y do not affect the data which set by ESC 2 or ESC 3.
· In stable mode, the printer uses vertical unit(y).
ESC
ESC
ESC
ESC m
m
m
m
[Name] Partial cut
[Format] ASCII ESC m
Hex 1B 6d
Decimal 27 109
[Description] The printer received this command, then executing partial cut at present position.
[Note] As the printer do not feed paper when executing this command, so before executing
this command in the next time, assure that feed paper at least 5mm or more, prevent cutter
broken.
[Default] Partial cut mode is default.
ESC
ESC
ESC
ESC \
\
\
\ nL
nL
nL
nL nH
nH
nH
nH
[Name] Set relative print position
[Format] ASCII ESC \ nL nH
To Next Page
Loading...