SP91 User Manual
Each data in stable mode (m=0, 48) and double height mode (m=2,50), the printer
prints one dot;
Each data under the double width mode (m=1, 48) and four double mode (m=3, 51),
the printer prints two dots.
[Reference] GS
GS
GS
GS *
*
*
*
GS
GS
GS
GS ：
：
：
：
[Name] Start/end macro definition
[Format] ASCII GS :
Hex 1D 3A
Decimal 29 58
[Description] Start/end macro definition
[Notes] · When receiving this command in stable operation, starts macro definition. When
receiving this command during macro definition, finishes the macro definition.
· During macro definition, when receiving GS ^, the printer stops macro definition and
clears macro definition.
· When turns the power on, undefined macro.
· ESC @ does not clear the content of macro definition. So, ESC @ could be
contained in macro definition.
·
If
the printer receives GS :, then receiving GS promptly,the printer stops on
undefined macro definition.
· The content of macro definition reaches to 2048 bytes.
If
the content of macro
definition overs 2048 bytes, so it can not store the over part of data.
[Reference] GS
GS
GS
GS ^
^
^
^
GS
GS
GS
GS H
H
H
H n
n
n
n
[Name] Select print position of HRI characters
[Format] ASCII GS H n
Hex 1D 48 n
Decimal 29 72 n
[Range] 0 ≤ n ≤ 3; 48 ≤ n ≤ 51
[Description] Print bar code, select print position of HRI characters.
n select print position, as following table:
n Print position
0, 48 Not print
1, 49 Above bar code
2, 50 Below bar code
3, 51 Above and below bar code
Note
Note
Note
Note ： Printing
Printing
Printing
Printing HRI
HRI
HRI
HRI character
character
character
character position
position
position
position does
does
does
does not
not
not
not set
set
set
set according
according
according
according to
to
to
to the
the
the
the standard
standard
standard
standard
position.
position.
position.
position.
· HRI （ Human Readable Interpretation ） indicates the barcode corresponding
characters.
[Note] · Print HRI character which set by GS F.
[Default] n = 0
[Reference] GS
GS
GS
GS f
f
f
f , GS
GS
GS
GS k
k
k
k
To Next Page
Loading...