Suunto Stinger - Page 80

78
2. Wait two seconds until the Adjustment Mode activates automatically. The altitude
setting starts to blink on the display (Fig. 4.16.).
3. Press
S to change the selection in the following sequence.
-> altitude adjustment -> personal adjustment -> units
4. While the altitude digits are selected (blinking), press + or - to change the Altitude
Mode (Fig. 4.16.).
5. While the personal adjustment digits are selected (blinking), press + or - to change
the Personal Adjustment Mode (Fig. 4.17.).
6. While the units are blinking in the lower part of the display, press + or - to change
units (Fig. 4.18.).
7. After you have set the desired adjustments, press the
M button to save the settings
and to return to the Setting Mode [SET] ).
WARNING
Always recheck the personal and altitude adjustment to ensure that the altitude
is not set for an altitude less than that of the dive site and that the personal mode
corresponds to the desired conservatism. Failure to enter this information could
result in dive planning errors and risk exposure to decompression sickness.