3.3 Autopause
Autopause pauses the recording of your activity when your speed is
less than 2 km/h (1.2 mph). When your speed increases to more than
3 km/h (1.9 mph), the recording continues automatically.
You can turn autopause on/off for each sport mode in Movescount
under the advanced settings for the sport mode.
3.4 Backlight
Pressing [LIGHT] activates the backlight.
By default, the backlight turns on for a few seconds and turns off
automatically.
There are four backlight modes:
•
Normal: The backlight turns on for a few seconds when you
press [LIGHT] and when the alarm clock sounds. This is the
default setting.
•
Off: The backlight is not switched on by pressing a button or
when the alarm clock sounds.
•
Night: The backlight turns on for a few seconds when you press
any button and when the alarm clock sounds.
•
Toggle: The backlight turns on when you press [LIGHT] and stays
on until you press [LIGHT] again.
You can change the general backlight setting in the watch settings
under GENERAL » Tones/display » Backlight. You can also change
the general setting in Movescount.
24
To Next Page
Loading...
