Suzuki Intruder 1978 - Page 115

4. Disconnect the wiring harness from the en-
gine.
5.
Slide the starter handle sideways through the
dash panel. Remove the rope from the guide.
6. Disconnect the fuel impulse li ne from the en-
gine as shown in Figure 3-24 .
1.
Impulse Line
Figure
3-24
7. Remove the carburetors from the engine by
loosening clamp screws and pulling from the
engine. If carburetors are to be removed, refer
to the carburetor repair instructions .
8. Disconnect control cable from oil pump . Re -
move
the oil inlet tube from the oil pump. In -
sert a bolt into the line to prevent oil loss.
9. Use a spring puller tool or a long wire hook to
disconnect the two exhaust springs.
10 . Remove the drive converter mounting bolt and
lockwasher . Install the dr ive converter puller
bolt (tool No. 57001-3502) and screw in to re-
move the drive converter.
(See Figure 3-25.)
Remove drive converter.
11 . Remove the four engine mounting screws from
PTO mount . (See Figure 3-26 .)
3- 42
ENGINE REMOVAL
12. Remove the two r ig ht hand side engine mount -
ing
bolts and shims.
13. Remove the eng
in e from the snowmobile.
14. Reinstall e ng ine in reverse order of removal.
When reconnecting the wiring harness, be
sure the main
wiring harness connec tor is fully
engaged to the e ng ine wiring harness con-
nector.
Install cab le tie ba nd around con-
nectors to prevent separation during engine
operation.
1. Drive
Converter Puller Bolt
Figure 3-25
1. Engine Mount Sc r ews
Figure 3-26
..