Suzuki Intruder 1978 - Fan Housing

Figure 3- 43
1. Fan Housing
Figure
3-44
3- 50 FAN HOUSING
NOTE: Spacers are used between the fan pulley
halves
to adjust fan belt tension. Using fewer
spacers increases fan belt tension. During
reassembly
place ha lf of the spacers removed
behind the inside pulley
half and the balance
outboard of the outside pulley half to maintain
proper be lt ali gnment .
1.
Spacers
2. Pu ll ey Halves
Figure 3-45
4. Using a heat gun or propane torch, heat
aluminum fan case allowing bearings to be
removed from fan case.
IWARNINGI
Do not contact heated fan housing with
bare hands or severe burn could result.
5. Using T ru-Arc or circlip pliers remove circlip
and two spacers from fan housing. (See Figure
3-
46 .)
NOTE: Circlip is used to correctly position
bearings.
Spacers are installed between bearings
to
eliminate side loads when shaft nut is tightened.
)
- ...