Suzuki Intruder 1978 - Speedometer; Tachometer; Tail Lamp

1 . Key Switc h
2. Panel
3. Bracket
Fig ure 3-91
Speedometer
Removal
1. Disconnect speedometer cable and remove the
light bulb assembly from the speedometer.
2. Remove the speedometer bracket. and remove
the speedometer from the
pa nel. (See Figure 3-
92.)
Figure
3-92
Installation
1. Install the speedometer to the panel and in -
stall the speedometer bracket.
2. Install the light bulb assembly. Connect the
speedometer cable and hand-tighten. (See
Fig ure 3-92 .)
Tachometer
Removal
1. Remove the light bulb assembly from the tach-
ometer, and disconnect
wires from the tach-
ometer.
2. Remove the tachometer bracket and remove
the tachometer from the console.
Installation
1. Install the tachometer in reverse order of re -
moval. (See Figure 3-93.)
Tail Lamp
Removal
Figure 3-93
1. Disconnect tail lamp harness from the main
harness.
2. Remove the seat and fuel tank.
3. Remove the tail lamp lens and gasket. (See
Figure 3-94.)
4. Remove the nuts securing the ta il lamp
assembly and remove the tail lamp assembly.
TAIL LAMP 3-67