1.
Injection Nozzle
Figure
3-65
3.
Remove the drain plug on the
front
of the gear
case and drain the case.
(See Figure 3-66.)
1. Drain
Figure 3-
66
4. Remove the bolts securing the gear case cover
to the crankcase and remove the gear case
cover.
(See Figure 3-67.) Check to see
if
the
small spacer used on the idler gear came off
with
the
cover and if
so,
remove it
so
it
will
not
become
lost. (See Figure 3-67.)
3-
58
01 L
INJECTION
SYSTEM
Figure
3-67
5.
Remove the idler gear. Take care not to lose
the spacer in back of the gear. (See Figure 3-
68.)
1.
Idler Gear
2.
Spacer
Figure
3-68
6. Install
the
fan puller holder tool
No
.
57001-
3506
into the
two
holes in the oil pump gear.
Remove the
nut
securing
the
gear to the pump
shaft and remove the gear.
7.
Remove the
two
bolts securing the oil pump to
the crankcase and remove
the
pump
. (See Fig-
ures 3-69 and
3-70.)
To Next Page
Loading...
