Suzuki Intruder 1978 - Page 84

Preliminary Ignition
Troubleshooting
Procedures
STATOR ASSEMBLY
EMERGENCY
STOP SWITCH
'"
WHITE
RED
COl IGNITER
z
S
~~
Uco
«
....J
co
When an ignit ion problem is present, prior to per-
forming elaborate troubleshooting try to solve your
problems by performing the easy tests first.
1. Remove
the key switch and emergency stop
switch circuits from the system. (See Figure 3-
1.) Separate
wiring harness connector on the
engine.
a. Start the engine. If the engine runs prop-
erly with the connector separated, ignit ion
components on
the engine are ok, then it must
be th e key switc h, the emergency stop switch
or the wiring . Refer to Key Switch and Emer-
gency
Stop Swit ch Tests.
b.
If the engine ignition problem still exists,
test
the ignition components mounted on the
engine.
o
KEY SWITCH
1. Engine Wiring Connector
Figure 3-1
ELECTRICAL TROUBLESHOOTING 3-11