Suzuki Intruder 1978 - Page 91

Test No.3
Magneto Pulser Coil Output
COl IGNITER
STATOR
ASSEMBLY
z
S
o
a:
~O)
u
EMERGENCY
STOP SWITCH
"
TEST CONNECTIONS
:5
1. With both the red and white wires still discon-
nected, connect
the tester N (yellow) lead wire
to the white wire on the magneto end of the
connector .
2.
Connect the tester P (red) lead wire to a good
engine ground.
3 -
18 ELECTRICAL TROUBLESHOOTING
o
KEY SWITCH
TEST PROCEDURE
1. Set the toggle switch to the Low range. Set the
tester dial to 90 .
2. Turn over the engine wh ile observing the In-
dicator Lamp on the tester.
a. If the Indicator Lamp lights, push the Reset
button
to turn the lamp off and repeat Test No.
3
three times . If the lamp lights consistently at
90 the pulser coil is good, proceed to Test No.
4.
b. If the Indicator Lamp gives inconsistent
readings or does not light at all, follow the
steps on the next page.