6-9
ELECTRICAL
SYSTEM
• Prepare the
ignitor
checker
lead
wire
"MODE
4"
<ID
which
comes supplied
with
the
ignitor
checker and connect its end
to
the COl
unit
and another
end
to
the checker.
• Connect the power source
leads
CD
to
the battery.
CAUTION:
*
Be
sure
the Black
lead
is
connected
to
the battery e ter-
minal and Red lead
to
the
EB
terminal.
* Before connecting the power source leads, make sure both
"POWER"
button
and
"START"
switch
are
in
"off"
posi-
tion
(POWER
button
not
depressed).
NOTE:
Be
sure the
battery
used
is
in
fully-charged condition.
CHECK PROCEDURE:
With all the lead wires properly connected, check the
CD
I
unit
as
follow.
Depress
"MODE
4"
button
then "POWER" button. This time,
"POWER"
lamp should come on.
If
not,
battery
is
under-
charged.
NOTE:
In
this check, the
monitor
does
not
operate.
• Remove
the
spark plugs
from
front
and rear cylinders.
Connect the respective plug
caps
and
place the spark plugs
on the cylinder
head.
If
blue
hot
sparks
are
seen
in the spark plugs, the system
is
functioning properly.
NOTE:
This checking presupposes
that
the ignition
coil
and the signal
generator
coil
used
for
checking
are
good
ones.
CAUTION:
When
making this test, keep the fire away
from
the cylinder
head.
SUZUKI
IGNITER
CHECKER
Pt.AT
NO,DM-"Im
MONITOR
IQt
ICt
c c
TACHO
co
MODE POWER
12:1451
~
IHJIHHJIJ
g
START
STOP
To Next Page
Loading...
