3·37
ENGINE
ENGINE REASSEMBLY
This engine
is
reassembled by carrying
out
the
steps
of
disassembly
in
the
reverse order,
but
there are a
number
of
steps which demand special descriptions
or
precautionary measures.
NOTE:
Apply
engine
oil
to
each
running and sliding
part
before reassembling.
• Apply a little grease
to
the
oil seal lip.
99000·25010: SUZUKI SUPER GREASE
"A"
• Install
the
drive shaft bearing retainer together with
the
gasket.
• When tightening
the
screws, applySUZUKI
BOND
No.1215
to
threads
of
them.
99000·31110: SUZUKI BOND No. 1215
• Position
the
crankshaft ®
in
the
crankcase lower half
CD.
This time, position
the
bearing locating pins ®, @ and ©
at
the
mating face
as
shown. Also, insert the C·ring @ into
the
crankcase groove properly.
CAUTION:
Position
the
oil seal squarely
to
the
crankshaft.
• Apply oil
to
the
bearings.
NOTE:
Use
Suzuki CCI
Oil
or
equivalent. Keep the crankcase mating
surface clean, free from oil.
To Next Page
Loading...
