Suzuki RGV250T 1996 - Page 151

CALlPER REMOVAL AND
DISASSEMBLY
• Remove the union bolt and catch the brake fluid in a suit·
able receptacle.
• Remove the caliper mounting bolts.
NOTE:
Slightly loosen the caliper housing bolts to facilitate later dis·
assembly.
• Remove the pads. (Refer to page 7 -23,)
• Remove the caliper housing bolts and separate the caliper
halves.
CD Caliper
<ID Pad
@Shim
@Clip
@Spring
@Pin
• Remove the O-ring.
NOTE:
Once the caliper halves have been separated, replace the O·ring
with a
new one.
• Place a rag over the piston to prevent it from popping out
and push out the piston by using air gun.
CAUTION:
To prevent piston damage, do not use high pressure air.
CHASSIS 7·24