EasyManua.ls Logo

Suzuki RGV250T 1996 - Page 182

Suzuki RGV250T 1996
334 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8ยท5
SERVICING
INFORMATION
BATTERY
Complaint
Symptom and possible causes
Remedy
Battery runs down
1. The charging system
is
defective.
Check
the
generator, regulator/rectifier
quickly.
and circuit connections, and make
necessary adjustments
to
obtain
specified charging operation.
2. Cell plates have lost much of their active
Replace
the
battery, and correct
material
as
a result
of
over-charging.
the charging system.
3. A short-circuit condition exists within
Replace
the
battery.
the
battery due
to
excessive accumulation
of
sediments caused by
the
incorrect electrolyte.
4. Battery
is
too
old.
Replace
the
battery.
Reversed
battery
The battery has been connected
the
wrong way
Replace
the
battery and be sure
to
polarity.
round
in
the
system, so
that
it
is
being charged
connect
the
battery properly.
in
the reverse direction.
Battery discharges
1.
Dirty container
top
and sides.
Clean.
too
rapidly.
2.
Battery
is
too
old.
Replace.
BRAKES
Complaint
Symptom and possible causes Remedy
Insufficient brake
1.
Leakage
of
brake fluid from hydraulic system.
Repair or replace.
power.
2. Worn pads.
Replace.
3.
Oil
adhesion on engaging surface of pads. Clean disc and pads.
4. Worn disc.
Replace.
5. Air
in
hydraulic system. Bleed air.
Brake squeaking.
1.
Glazed pad surface. Repair surface with
sandpaper.
2. Tilted pad.
Modify pad fitting.
3. Damaged wheel bearing.
Replace.
4. Loose front-wheel axle or rear-wheel axle.
Tighten
to
specified torque.
5. Worn pads.
Replace.
6. Foreign material in brake fluid. Replace brake fluid.
7. Clogged return
port
of
master cylinder.
Disassemble and clean
master cylinder.
Excessive brake
1. Air
in
hydraulic system. Bleed air.
lever stroke.
2. Insufficient brake fluid.
Replenish fluid
to
specified
level; bleed air.
3.
Improper quality
of
brake fluid. Replace with correct fluid.
Leakage
of
brake fluid.
1. I nsufficient tightening
of
connection joints. Tighten
to
specified torque.
2. Cracketl hose.
Replace.
3. Worn piston and/or cup. Replace piston and/or cup.

Table of Contents

Related product manuals