Suzuki RGV250T 1996 - Page 298

11·9 RGV250N ('92·MODEL)
REASSEMBLY
• Install the ends of the spring into the hole ® in the oil
pump pulley and hole @ in the actuator pulley .
• Set the groove
© in the oil pump pulley to the lug @on
the actuator pulley.
THROTTLE SENSOR
CAUTION:
Do not remove the throttle sensor CD from the throttle cable
case ®. This component is PRE-SET at the factory by the
very specialized equipment.
FRONT FORK
The oil seal housing is combined to the outer tube.
Dust
seal
Spring
M-model
Outer
tube
Oil seal
housing
Spring
N-model
Outer
tube