Suzuki RGV250T 1996 - Page 38

3-5 ENGINE
• Remove the engine sprocket from the drive shaft using the
snap ring pliers.
09900-06107:
Snap ring pliers
•
Remove the gear shift lever.
• Loosen the
rear axle nut and drive chain adjusters.
•
Push the rear wheel forward or remove the rear wheel, and
disengage the drive chain from the rear sprocket.
•
Disengage the drive chain from the engine sprocket, and
remove the engine sprocket.
•
Remove the oil pump inspection cap.
• Slightly pry the tab on the oil pump lever to remove the
control cable.
•
Remove the side stand switch.
•
Remove the right and left mufflers by unscrewing muffler
mounting bolts
and exhaust pipe clamp nuts.
NOTE:
When reinstalling the mufflers, a/ways use a new exhaust pipe
gasket.