Suzuki RGV250T 1996 - Page 41

• Disconnect the oil control cable CD.
• Disconnect the throttle cables CID and @.
• Disconnect the actuator cable @.
• Disconnect the throttle cable @.
• Loosen the exhaust valve cable adjuster ® .
• Remove the exhaust valve cable bracket (J).
• Remove the exhaust valve cables @ from the pulley.
• Remove
the thermostat case ®.
• Remove the electric parts holder ® from the frame.
• Remove
the actuator assembly @.
• Remove the actuator pulley @ from the shaft.
• Disconnect
the cables @.
ACTUATOR AND CABLE ASSEMBLY
• Verify that the line ® on the actuator shaft is pointing the
line @ on the body.
ENGINE 3-8