Suzuki RGV250T 1996 - Page 95

• I nstall the choke plungers CD and CID .
• Position the right and left carburetors properly and tighten
their clamp
screws.
• Connect the fuel hose @ .
• Connect the drain hoses @ .
• I nstall the throttle stop screw knob bracket on the frame.
The
rear bolt should be tightened together with the fairing
stay@ .
THROTTLE CABLE ADJUSTMENT
• Refer to page 2-6.
• Adjust the cable slack of right and left carburetors to
O.Smm.
• Loosen the lock
nut ® of carburetor and turn in or out the
adjuster
(j) of the carburetor until the specified value is
obtained.
FUEL AND LUBRICATION SYSTEM 4-8
~.~
~.:~