6-22
Oil Strainer (No.1) Cleaning
10.Remove the oil strainer cap 0.
Pull out the oil strainer No.1
A.
NOTE: Inspect the feed pump
side oil strainer (No.1) when the
engine oil is replaced.
B....Magnet
C....Clip
11.Check the oil strainer for any
damage or clogging. If the oil
strainer is damaged, replace
the oil strainer. If the oil
strainer is clogging, clean the
oil strainer in the following pro-
cedures.
NOTE: Clean the oil strainer thor-
oughly up to first 2 to 3 times
because steel particles will be
caught when the engine is new.
12.Remove the clip C.
CAUTION
Sharp edge steel particles
around the oil strainer magnet
can harm your fingers.
Wear protective gloves when
removing steel particles from
the oil strainer.
To Next Page
Loading...
