Suzuki RM85 User Manual

14-4 FRONT AND REAR WHEELS
FRONT WHEEL BEARING REMOVAL
• Fit the bearing remover into the wheel bearing.
 09921-20220: Bearing remover set
• Remove the bearings and spacer.
FRONT WHEEL BEARING REASSEMBLY
• Apply grease to the bearings.
• Reassemble the spacer and bearings with the special tool.
 09941-34513: Bearing installer set
NOTE:
* The sealed cover of the bearing must face outside.
* Reassemble the left side (disc side) bearing first and then
reassemble the right side bearing.
* After reassembling the bearings, inspect the bearings for
smooth movement.
FRONT WHEEL INSTALLATION
• Install the front wheel, axle collars and front axle.
• Tighten the axle nut to the specified torque.
 Axle nut: 44 N·m (4.4 kgf-m, 32.0 lb-ft)
• Replace the cotterpin with a new one.
Left Right
Clearance
Left Right

Suzuki RM85 Specifications

General

Engine Type	2-stroke, liquid-cooled, single cylinder
Displacement	84.7cc
Bore x Stroke	48.0 mm x 46.8 mm
Ignition	CDI
Transmission	6-speed constant mesh
Final Drive	Chain
Front Brakes	Single hydraulic disc
Rear Brakes	Single hydraulic disc
Compression Ratio	9.5:1
Front Suspension	Inverted telescopic, coil spring, oil damped
Rear Suspension	Swingarm type, coil spring, oil damped
Front Tire	70/100-17
Rear Tire	90/100-14
Overall Width	765 mm
Overall Height	1, 110 mm
Wheelbase	1, 240 mm (48.8 in.)
Curb Weight	73 kg (161 lbs.)
Fuel Tank Capacity	5.5 L