Suzuki SV650A - Page 112

SV650K7/SK7/AK7/SAK7 (’07-MODEL) 111
Step 4
1) Measure the resistance between

I terminal and ground at
the ABS control unit coupler.
$ Normal value: ∞ Ω (Infinity)
) Tester knob indication: Resistance (Ω)
Is the resistance between

I and ground OK?
Step 5
1) Measure the resistance between

1 terminal and ground at
the rear wheel speed sensor coupler.
$ Normal value: ∞ Ω (Infinity)
Is the resistance between

1 and ground OK?
Step 6
1) Check for continuity between

7 terminal on the ABS control
unit coupler and

2 terminal on the rear wheel speed sensor
coupler.
$ Normal value: Continuity (*)
+ Tester knob indication: Continuity test (*)
Is there continuity between

7 and

2?
Step 7
1) Check the continuity between

I terminal on the ABS control
unit coupler and

1 terminal on the rear wheel speed sensor
coupler.
$ Normal value: Continuity (*)
+ Tester knob indication: Continuity test (*)
Is there continuity between

I and

1?
YES Go to step 6.
NO Go to step 5.
YES Inspect the wire harness. (Faulty B/Y wire)
NO Replace the rear wheel speed sensor.
ABS control unit coupler
(Harness end)
Sensor side
YES Go to step 7.
NO Inspect the wire harness. (Faulty W/Y wire)
YES Go to step 8.
NO Inspect the wire harness. (Faulty B/Y wire)
]
ABS control unit coupler (Harness end)
Harness side
ABS control unit coupler (Harness end)
Harness side
SAMPLE