16
Configuration: Exceptions: Exception
An exception is any deviation from the DVR’s normal behaviour. It could mean the hard
drive is full or has an error, the DVR has been disconnected from the network or some-
one has tried to login with an incorrect username or password. The DVR can alert you
in multiple ways.
Exception Type: The event type you’d like the DVR to react to. You can enable any com-
bination of audio and email alerts to be activated for different event types.
HDD Full: As the name suggests, this event occurs when the hard drive has run out of
space. This event type becomes redundant if you have “Overwrite” enabled (see “Re-
cord: Advanced” on page 28).
HDD Error: This occurs when the DVR has difficulties accessing the hard drive.
Network Disconnected: This will occur if the DVR has difficulties connected to the
Internet. This may indicate a problem with the DVR’s configuration, a fault with the
network or an issue with the Internet connection on your router.
IP Conflicted: This will occur if the DVR detects another device on the same network
with a conflicting IP address.
Illegal Login: This will occur if the DVR detects an incorrect login.
Input/recording resolution mismatch: If the camera connected is not capable of
matching the resolution selected in the “Record: Encoding” menu.
Record Exception: This will occur if there are unexpected errors during capture such
as a hard drive failure, if the hard drive is full or if the hard drive quota has been
changed.
Audible Warning: The DVR will use its internal buzzer to emit an alarm tone.
Alert CMS Software: This will alert the SwannView Plus Windows software installed
on your computer.
Send Email: The DVR will send an email alert when the event type occurs.
Don’t forget to click “Apply” to save settings.
To Next Page
Loading...
