37
Camera Management: Video Loss
Video loss is regarded as a potential alarm event and is considered to occur any time
the DVR doesn’t receive an active video signal on any of its inputs.
When a input has no incoming video signal, a “NO VIDEO” message will appear. Please
note, don’t enable video loss for an input that does not have a camera connected.
Camera: Select a camera that you would like to edit.
Enable Video Loss Alarm: Click the checkbox to enable.
Handling: Here you can define what will happen when the camera you’ve selected has
no incoming video signal. You can trigger additional cameras to start recording, you
can adjust your arming schedule, send alerts to the SwannView Plus software and to
send an email.
Use the “Copy” function to apply these settings to the other cameras.
Don’t forget to click “Apply” to save settings.
Camera1
26/08/2014 Tue 11:30:15
To Next Page
Loading...
