SWF K Series

55--55
󱀥 Go to # 35 room in <Fig. 5.2-4> and press . (the square room with slashes)
Then a new window appears as in <Fig. 5.2-5>. On the left-hand side, the chosen design is displayed. On the
right-hand side of the screen, the information on the design is displayed. On the screen, such buttons as
, , , are enabled.
SELECT
F4
EXPORT
F3
COPY
F2
DELETE
F1
SELECT
F7
󱀦 Press .
The selected embroidery design will be called and displayed on the initial screen as in <Fig. 5.2-6>.
SELECT
F4
[ Note ]
On the embroidery information section, “OPTION NORMAL”might be seen. “Normal”refers to common embroidery
data. Sometimes, “Sequin”might be displayed. It means that it is the embroidery design including the sequin code.
[Fig. 5.2-5]
[Fig. 5.2-6]