5.9.1 Origin
Origin is the function which can be used during the pause of the embroidery work. This has the same function as
“Return to Origin” as in and moves the needle bar to the origin of the design. Press to
activate the function.
5.9.2 Holding
This function is to operate the holding solenoid. Press to activate it.
5.9.3 Needle DN/UP
In order to lower the needle bar and set the accurate position of the first stitch, press the needle bar descend button.
And then use the frame move key to set the accurate position. Press the needle bar ascend button to put back the
needle bar.
5.9.4 Language
This function is to enable users to choose a language among nine languages including Korean, English, Spanish,
Germany, Danish, Italian, Indonesian, Chinese, and Turkish for easier understanding.
Select a desired language.
5.9.5 Sequin Lift / Sequin Feed
This function is to test the sequin device when it is equipped. The sequin lift lowers the sequin device closer to the
needle plate or raises it for testing. The sequin operation function is to test whether the sequin device supplies the
sequin one by one when it is located closer to the needle plate.
5.9.6 Trim
This function is to enable the user to conduct manual trimming when it is necessary beyond the design code-driven
automatic trimming. It should be chosen for manual trimming.
5.9.7 PF UP/DOWN
The PF Up/Down function is used to manually check or set the presser foot. Select the function and press the start
key. Then the function is in operation.
To Next Page
Loading...
Need help?
General
