<Fig. 6.0-1> is the screen which appears when embroidery work is paused. Basically, the screen has the similar
layout to the screen before embroidery begins. However, “Ready”, “Repeat”, and “Tools” were removed from the
main function menu. Instead, they were replaced with “Float”, “Frame”, and “S_Code”. In addition, in the settings,
some menus are disabled. Before embroidery begins, various settings might be made, but the setting change might
be necessary during embroidery for better results. In preparation for the situation, let's find more about the functions
during embroidery is paused.
In this section, the explanation will focus on the different part of the menu compared with the menu before
embroidery begins, such as “EMBCall”, “Setting”, “Float”, “Frame”, and “S_Code”.
[Fig. 6.0-1]
[ Note ]
To conduct the operation without needle by using the Pause Menu During Embroidery, press the pause
switch, and the screen shows the “Pause Menu during Embroidery”.
6
Function Menu During Embroidery Pause
To Next Page
Loading...
Need help?
General
