19
with drying agent.
●
Proper handling of the microscope will ensure years of trouble free
service.
●
If repair becomes necessary, please contact your Swift agency or our
Technical Service direct.
Note:
●
If equipment is used in a manner not specied by the manufacturer, the
warranty may be void.
●
To avoid getting wet, do not use the microscope near water.
E. Bulb replacement
The lamp and the lamphouse become very hot during and after a
period of operation.
Risk of burn – Do not touch the lamp during or immediately after period
of operation.
Make sure the lamp has cooled suciently before attempting to replace
the lamp.
i. Raise the stage up to the top position. Rotate the light
collector in anticlock direction and remove it from microscope base.
ii. Loosen LED board clamp screws using hexagon wrench (included),
take out LED board.
To Next Page
Loading...
Need help?
General
