EN
28
Generate the corresponding connection by "auto detect" via flag "connection"
In exceptional cases it is also possible via manual choice "COM choice".
7.2 Basic Parameters
The start page provides the most important operating and display values.
The individual parameters are fully described in chapter 8.6.
Additional operating windows:
• 7.3 Help data file
• 7.4 Operation values
• 7.5 Remote control
• 7.6 Motor parameters
• 7.7 V/Hz-Table
• 7.8 Motor control parameters
• 7.9 Spindle start-up
• 7.10 Special programs
To Next Page
Loading...
