SycoTec easyDive 4425 - Warranty Conditions; CE Declaration of Conformity

EN
59
F • 55 W Offset in current measuring circuit (l_wr) too large in self-test
C • Internal failure
R • Switch on and off several times. If the fault still exists, send in frequency inverter for repair.
F • 56 W Offset in current measuring circuit (l_wr_neg) too large in self-test
C • Internal failure
R • Switch on and off several times. If the fault still exists, send in frequency inverter for repair.
F • 57 W Actual motor speed too high
C • Actual speed lies 10% over nominal speed. Motor cannot follow the nominal speed. Motor externally
driven
R • Set the nominal speed at a lower level
F • 58 E BLDC motor does not start
C • Despite several attempts, the motor does not start
R • Check motor and supply lines. Adjust P46-t_rise, P51-t_start, P52-I_start
F • 63 W Fault while loading the parameter from the EEPROM data bank
C • Reading/writing fault in EEPROM
R • Reset EEPROM via special programs/factory setting
F • 64 W Fault while loading the calibration value from the EEPROM data bank
C • Reading/writing fault in EEPROM
R • Reset EEPROM via special programs/factory setting
Warranty Conditions
Under current SycoTec delivery and payment conditions, SycoTec undertakes warranty for satisfactory
function and freedom from faults in material and manufacture for a period of 12 months from the date of
sale certified by the vendor.
In the event of justifiable complaints, SycoTec shall supply spare parts or carry out repairs free of charge
under warranty. SycoTec accepts no liability for defects and their consequences which have arisen or
could have arisen as a result of natural wear and tear, improper handling, cleaning or maintenance, non-
compliance with the maintenance, operating or connecting instructions, corrosion, impurities in the air
supply or chemical or electrical influences which are unusual or not admissible in accordance with
SycoTec's standards. The warranty claims shall become null and void if defects or their consequences
can be attributed to interventions in or modifications to the product. Warranty claims can only be
validated if they are notified immediately in writing to SycoTec.
A copy invoice or delivery note clearly showing the manufacture number shall be attached if products are
returned.
CE Declaration of Conformity
The CE Declaration of conformity may be requested or downloaded from www.sycotec.eu.