Sym MaxSym 600i ABS Service Manual

4. Fuel Injection System
4-43
Fault Code and Check Light Flashing Lighting Identification Table
No.
Fault
codes
Fault Description
Check
light
Check light flashing
state
Parts Inspection
1
0120
Throttle position sensor fault
Lighting
long 0，short 6
Throttle position sensor and wire
Fault detection procedures Please refer to the "EFI System components description" throttle position sensor
(TPS) chapter
2
0105
Manifold Absolute Pressure sensor fault
lighting
long 0，short 9
MAP sensorand wire
Fault detection procedures Please refer to the "EFI System components description" manifold Absolute
Pressure sensor (MAP) chapter
3
0115
Engine temperature sensor fault (water)
lighting
long 1，short 2
Engine temperature sensor and wire
Fault detection procedures Please refer to the "EFI System components description" engine temperature
sensor (WPS) chapter.
4
0195
Engine oil temperature sensor fault (oil)
lighting
long 1，short 1
Engine temperature sensor and wire
The current reservation
5
0110
Intake temperature sensor fault
lighting
long 1，short 3
Intake temperature sensorand wire
Fault detection procedures Please refer to the "EFI System components description" intake temperature
sensor (TAS) chapter.
6
1630
Roll over sensor fault
lighting
long 1，short 5
Roll over sensor and wire
Fault detection procedures Please refer to the "EFI System components description" Roll over sensor chapter.
7
0130
O
2
sensor fault
lighting
long 1，short 7
O2 Sensorand wire
Fault detection procedures Please refer to the "EFI System components description" O2 sensor chapter.
8
0201
ＩＮＪ #1 fault
lighting
long 3，short 3
Injector and wire
Fault detection procedures Please refer to the "EFI System components description" fuel injector chapter.
9
0351
IG #1 fault
lighting
long 3，short 7
Ignition coil and wire
Fault detection procedures to adhere to the traditional way
10
0230
Fuel pump fault
lighting
long 4，short 1
Fuel pump and wire
Fault detection procedures Please refer to the "EFI System components description" fuel pump chapter.
11
0135
O2 sensor heater fault
lighting
long 4，short 5
O2 Sensorand wire
Fault detection procedures Please refer to the "EFI System components description" O2 Sensor chapter.
12
1505
ISC motor fault
lighting
long 4，short 9
Step motor and wire
Fault detection procedures Please refer to the "EFI System components description" idle speed control valve
(ISC) chapter.
13
1410
Exhaust 2
nd
air solenoid valve fault
lighting
long 5，short 4
2
nd
air control valve and wire
Fault detection procedures Please refer to the "EFI System components description" 2
nd
air solenoid valve
chapter.
14
0335
Crankshaft position sensor fault
lighting
long 6，short 6
Crankshaft position sensor and wire
Fault detection procedures Please refer to the "EFI System components description" Crankshaft position
sensor chapter.
15
1205
PM wire fault
lighting
long 6， short 8
Manifold absolute pressure sensor
and wire
Fault detection procedures Please refer to the "EFI System components description" Manifold absolute
pressure sensor (MAP) chapter.
16
0603
EEPROM fault
Not lit
long –，short –
EEPROM
This fault Please direct replacement ECU
To this chapter contents

Sym MaxSym 600i ABS Specifications

General

Brand	Sym
Model	MaxSym 600i ABS
Category	Scooter
Language	English