In the anti-theft alert, the
switch is forced to open,
and the main switch is
opened to enter the
periodic sound and light
alarm (after 8 consecutive
cycles, the silent warning
light flashes into the single
tone alarm)
10. SPECIFICATION
Working voltage: 12V
Static current: average≤ 3.5ma
Working current: ≤ 600A
Modulation mode: ASK
Working voltage of remote control: 3V
Horn sound level: 90-115db
Working frequency: 433.92mhz
CAUTION：
1. When using the spare key, insert and remove the key in the same gear。
2. When leaving the vehicle, make sure that the main switch is turned to "lock"
3. Please keep the spare key "key code" aluminum plate properly. If the key is lost, you can order
a new spare key from the dealer with the "key code". If the key is not available, it may cause
your car to fail to start.
4. Ensure the battery capacity≥ 8ah.
5. If the vehicle is not riding for a long time, the battery must be disconnected and the battery
should be charged and maintained every month.
6. The effective distance of the remote control button must be more than or equal to 20 meters.
Please avoid touching the remote controller within the effective distance to unlock the vehicle.
7. When the operating distance of the remote control is less than 10 meters, pay attention to
replace the built-in battery of the remote control, and the battery specification must be
consistent with sym factory specification.
8. Pay attention not to install other electronic components not approved by SCN, so as to avoid
frequent abnormal power loss of vehicle battery.
9. Please do not directly expose the remote controller to the sun and rain.
10. In noisy and vibration environment, it is necessary to consider whether fortification is necessary
to prevent battery power loss caused by long-time alarm.
11. The remote control battery is not in the three packs.
12. If the user disassembles the machine by himself or is damaged artificially, it is not covered by
the warranty.
To Next Page
Loading...
Need help?
General
