Operating Procedures
Cautions on Use in Water
If you leave water at a sharp angle, the
rear of the machine may be submerged,
exposing the radiator fan to water and
damaging them. Do not let the rear of the
machine get submerged.
�
Allowable water depth
In water, only use the machine up to a
depth at which the water comes up to
the middle of the shoe slide (1).
�
When greasing places used under water
for long periods of time, apply enough
grease so that the old grease is expelled.
�
Never submerge the slew bearing or main
body in water or sand. If the slew bearing
or main body should get submerged,
contact a Takeuchi sales or service outlet
for inspection.
Cautions on Traveling on Slopes
WARNING
� Never exceed the machine’s stability
capabilities (maximum gradeability
–30°, lateral tipping angle –15°). Also
note that when actual working area
conditions are poor the machine’s
stability capabilities may be lower.
�
When traveling on slopes or grades,
lower the bucket to a height of 20 to
30 cm (8 to 12 in.) off the ground. In
emergencies, lower the bucket to the
ground and stop the machine.
�
When traveling on slopes or grades,
move slowly in first gear (low speed).
�
Do not travel down slopes in reverse.
�
Do not change directions or cross
slopes sideways. First return to a flat
surface then redirect the machine.
�
On grass, dead leaves, wet metal or
frozen surfaces, the machine may
slide sideways even on very gentle
slopes. Make sure the machine never
faces sideways with respect to the
slope.
To Next Page
Loading...
