Rollshutter Installation Instructions, 10
©Copyright TALIUS
While a helper is feeding the tape from the tape operator, start turning the shaft as if the shutter was rolling in a
downward rotational direction. This will result in loading tape onto the tape wheel. Continue until all the tape from the
tape box is used up. Then reverse the process and put approximately 18" (50cm) of tape back into the tape operator.
This will ensure a few windings so that the end of the tape does not tear off its fastening point in- side the operator. If
the operator consists of a pull tape operator, place a large flat screwdriver in the tape exit slit or tie a slip knot to
prevent the spring from reeling the tape back in again.
To Next Page
Loading...