Rollshutter Installation Instructions, 2
©Copyright TALIUS
Contents
Preparation for Through Wall Operator Applications
Mounting Rails and Panel Box
Loading Curtain Into Guide Rails
Attaching Curtain to Shaft
Limit Setting for Motorized Operators
Recommended Installation Tools and Materials:
Each Rollshutter installation requires a minimum of 2 installers. Not all installations are the same. While the following
items will not be required on every installation, this is a list of minimum requirements that we recommend for the
majority of Rollshutter installations. While we do not supply common tools and hardware, contact us to purchase the
specialized tools like motor tester cables.
Please note: Talius does not supply the fasteners for installation. We believe this is better handled by
the Talius Dealer, based on the on-site construction considerations.
Level 4’, tape measure, markers
Side cutters, wire strippers
Short and tall ladders, tool pouch
Cordless drill, indexed drill bit set
Masonry drill or ½" hammer drill
Spare lag bolts, masonry anchors
Full screwdriver set, multi-driver set
Long ؽ" (13mm) and ؾ" (19mm)
Needle-nose pliers, regular pliers
Drill bits, block of wood
035-.040"(0.9 - 1.0mm) feeler gauge
Rivet gun, variety of spare rivets
Caulk gun, caulking and sealants
Touch-up paint and brushes: brown,
white, silver, beige, and black
Extension cords, cleansers, rags
Ø8.5mm/Ø5mm step drill bit
Wood and concrete chisels, hammer
Tubular motor limit combs /
adjusters
Ø10mm/Ø5mm step drill bit
Electrical tape, masking and duct tape
Tubular motor tester cable
To Next Page
Loading...